Ozone-enhanced catalytic oxidation of monochlorobenzene over iron oxide catalysts

In this study, we examined the experimental catalytic oxidation of gaseous monochlorobenzene (MCBz) with O₃ over Fe₂O₃ in a packed bed reactor to investigate the feasibility of economical low temperature decomposition at a high space velocity (SV). We investigated the effects of several reaction parameters (temperature, O₃ concentration, and SV) on the MCBz oxidation. At 150 °C, the conversion of MCBz over Fe₂O₃ in the absence of O₃ was only 3%; it increased to 91% over Fe₂O₃ in the presence of 1200 ppm of O₃ at a high SV of 83 s⁻¹. A long-term operation study revealed that the conversion of MCBz was stable for more than 96 h. In the steady state, the carbon and chlorine balances were 88% and 86%, respectively. Applying a Langmuir-Hinshelwood kinetic model, we estimated an activation energy of 16.7 kJ mol⁻¹ for MCBz oxidation over Fe₂O₃ in the presence of O₃.     

UASB反应器中厌氧氨氧化菌的影响因素研究

在UASB反应器中接种实验室已经驯化好的厌氧氨氧化颗粒污泥，对其进行厌氧氨氧化菌活性提高和影响因素的实验研究。研究表明厌氧氨氧化菌对NH4＋-N和N02--N的适宜浓度负荷均为200mg／L，适宜水力停留时间HRT、温度、pH和进水基质比（N02--N／NH4＋-N）分别为2h、30～35℃、7．5～8．5和0．95～1．2，NH4＋-N、NO2--N和TN的平均去除率分别为97．1％、98．3％和92．7％。     

煤低温氧化热解的热分析实验研究

在热分析动力学的基础上,对阳泉煤样运用同步热分析仪进行150℃下的氧化以及热解实验,得出该煤样相应的TG-DSC曲线。通过两者的TG-DSC曲线,对比分析煤样的热量释放情况,并结合曲线设定多项式形式的机理函数以分析其动力学特性。实验研究得出:该煤的低温氧化过程较之热解过程是个明显的氧化放热过程;该煤低温氧化和热解过程的最佳机理函数都为多项式,并且相应过程中的TG曲线和DSC曲线适用于同一个机理函数,这与一般所定义的机理函数不同;热解过程较之氧化过程所需的表观活化能较大,相同条件下较易发生煤的氧化自燃。     

Aqueous suspensions of carbon nanotubes: Surface oxidation, colloidal stability and uranium sorption

The objective of this study is to obtain information on the behaviour of carbon nanotubes (CNTs) as potential carriers of pollutants in the case of accidental CNT release to the environment and on the properties of CNTs as a potential adsorbent material in water purification. The effects of acid treatment of CNTs on (i) the surface properties, (ii) the colloidal stability and (iii) heavy metal sorption are investigated, the latter being exemplified by uranium(VI) sorption. There is a pronounced influence of surface treatment on the behaviour of the CNTs in aqueous suspension. Results showed that acid treatment increases the amount of acidic surface groups on the CNTs. Therefore, acid treatment has an increasing effect on the colloidal stability of the CNTs and on their adsorption capacity for U(VI). Another way to stabilise colloids of pristine CNTs in aqueous suspension is the addition of humic acid.     

基于成本-效能分析的氧化沟工艺运行条件优化

在利用ASM2d模型对城市污水处理厂氧化沟工艺进行动态模拟的基础上,将曝气能耗、污泥产量与出水水质超标率整合为一个综合效能指数,对该工艺进行了成本-效能分析。最优运行策略为:3～10月温度高于15℃时运行8台曝气转刷,其余时间段运行10台转刷,同时剩余污泥排放量控制在250 m3/d。这一策略能够使出水NH4-N和TN的超标率分别低于5%和2%,保证出水TP的持续达标,与常规运行策略相比,在明显降低氮磷超标率的同时,节省曝气能耗约12%。     

Degradation of ethylenethiourea pesticide metabolite from water by photocatalytic processes

In this study, photocatalytic (photo-Fenton and H₂O₂/UV) and dark Fenton processes were used to remove ethylenethiourea (ETU) from water. The experiments were conducted in a photo-reactor with an 80 W mercury vapor lamp. The mineralization of ETU was determined by total organic carbon analysis, and ETU degradation was qualitatively monitored by the reduction of UV absorbance at 232 nm. A higher mineralization efficiency was obtained by using the photo-peroxidation process (UV/H₂O₂). Approximately 77% of ETU was mineralized within 120 min of the reaction using [H₂O₂]₀ = 400 mg L^?1. The photo-Fenton process mineralized 70% of the ETU with [H₂O₂]₀ = 800 mg L^?1 and [Fe²⁺] = 400 mg L^?1, and there is evidence that hydrogen peroxide was the limiting reagent in the reaction because it was rapidly consumed. Moreover, increasing the concentration of H₂O₂ from 800 mg L^?1 to 1200 mg L^?1 did not enhance the degradation of ETU. Kinetics studies revealed that the pseudo-second-order model best fit the experimental conditions. The k values for the UV/H₂O₂ and photo-Fenton processes were determined to be 6.2 × 10^?4 mg L^?1 min^?1 and 7.7 × 10^?4 mg L^?1 min^?1, respectively. The mineralization of ETU in the absence of hydrogen peroxide has led to the conclusion that ETU transformation products are susceptible to photolysis by UV light. These are promising results for further research. The processes that were investigated can be used to remove pesticide metabolites from drinking water sources and wastewater in developing countries.     

The oxidation mechanism of polychlorinated dibenzo-p-dioxins under the atmospheric conditions - A theoretical study

The atmospheric polychlorinated dibenzo-p-dioxins (PCDDs) partition appreciably in the gas phase, where they undergo rapid oxidation. The atmospheric oxidation mechanisms of a few PCDDs, initiated by OH radical, are studied using density functional theory calculations. The oxidations start with OH-addition to the aromatic rings, dominantly at γ-sites, followed by the non-chlorinated β-sites; while additions to the α-sites or chlorinated sites are negligible. For PCDDs with all β-sites being chlorinated, formation of PCDD-γ-OH adducts become virtually the only reaction path. Under the atmospheric conditions, the PCDD-β/γ-OH adducts combine with O₂ slowly at rates <1 s⁻¹. Instead, the PCDD-β-OH adducts will react with O₂ through hydrogen abstraction at rates <50 s⁻¹, forming PCDD-β-ol, and the PCDD-γ-OH adducts will decompose to the substituted phenoxy radicals by fused-ring C-O bond cleavage at rates of 10³ ∼ 10⁵ s⁻¹. The reaction mechanisms of PCDDs are drastically different from the peroxy mechanism for the atmospheric oxidations of benzene and dibenzofuran.     

纳米TiO2/活性炭复合光催化剂的制备及其对甲醛气体降解

研究了纳米TiO2/活性炭复合光催化剂对空气中典型污染气体甲醛的光催化降解特性。采用扫描电镜（SEM）表征复合催化剂的表面特征。结果显示,经改性后的纳米TiO2在复合催化剂表面分布均匀,呈球状。对甲醛气体的降解实验显示TiO2负载量为1%时对甲醛的去除效果最好,6 h去除率为61.7%。结果显示复合催化剂把甲醛气体分解成CO2,可以直接排空,无二次污染。     

A2O氧化沟缺氧区三维流场模拟及结构形式优化

以FLUENT软件为工具，选用三维RNG k-ε紊流数学模型对重庆井口污水厂A²O氧化沟缺氧区内的流场进行模拟，分析了缺氧区内流场分布不均匀及沉泥的原因，提出了水下推进器的合理设置位置与导流墙的合理设置方式，并对优化后的缺氧区进行了模拟计算。通过优化后模拟的结果可见，在相同的功率密度下，缺氧区内的流场得到了较均匀的分布，流速从原来的0.131 m/s提升到0.204 m/s，减少了能量的损失。底部的流速也从原来的0.140 m/s提升到0.226 m/s，有效的防止或减少了沟中的污泥沉积。优化的结果对实际工程的设计也有一定的指导意义。     

Stabilization of potassium permanganate particles with manganese dioxide

A new potassium permanganate reagent with slow-release properties was designed and tested for possible application in in situ chemical oxidation. For this purpose, MnO₂-coated KMnO₄ particles (MCP) were prepared by partial reduction of solid KMnO₄ using the acid-catalyzed reaction with n-propanol or the comproportionation of Mn(VII) and Mn(II) in n-propanol as reaction medium. Column tests showed that, for MCP with a residual KMnO₄ fraction of 70 wt%, the duration of permanganate release under flow-through conditions was prolonged by a factor of 10 compared to untreated KMnO₄. While KMnO₄ is too soluble to be used in reactive barriers, MCP could be introduced into the aquifer by filling of trenches or boreholes; this would allow a prolonged passive dosing of permanganate into the flowing groundwater. In addition, experiments were conducted in order to determine the oxidation capability of native KMnO₄ particles and MCP in CH₂Cl₂, a representative non-polar non-aqueous phase liquid (NAPL). It may be possible to utilize the significantly higher reactivity of MCP under these conditions for the design of slow-release permanganate particles for NAPL source treatment.